Skip to main content
Loading…
This section is included in your selections.

Table 30.86.410 Mechanical Permit Fees

COMMERCIAL MECHANICAL PERMITS NOT ASSOCIATED WITH NEW BUILDING CONSTRUCTION

For mechanical permits on commercial projects not related to new building construction, the fee table in SCC 30.86.400(7) applies based on the valuation.

MECHANICAL INSPECTION FEES FOR CONSTRUCTION OF NEW GROUP R-3 OCCUPANCIES (ONE-AND TWO-FAMILY RESIDENTIAL).

For new construction of Group R-3 occupancies, 11 percent of the building permit fee shall apply for mechanical and plumbing inspections.

The per-fixture fees below apply to: (1) standalone mechanical permits related to Group R-3 occupancies, and (2) mechanical permits associated with new commercial building construction.

GAS-PIPING SYSTEM

$5 per outlet

VENTILATION FAN OR SYSTEM - installed, which is not a portion of any heating or air conditioning system authorized by permit

$5

AIR-HANDLING UNIT - install, and including ducts attached thereto

$15 each

APPLIANCE VENT TO THE OUTSIDE - install or relocate, and not included in an appliance permit

$15

BOILER, COMPRESSOR, OR ABSORPTION SYSTEM - install or relocate(1)

$15

DOMESTIC OR INDUSTRIAL-TYPE INCINERATOR - install or relocate

$15

FLOOR FURNACE - install or relocate, including exhaust vent, suspended heater, recessed wall heater, or floor-mounted unit heater

$15

FURNACE OR BURNER - forced air or gravity-type: install or relocate, including ducts and vents attached

$15

HOOD - install, which is served by mechanical exhaust, including the ducts for such hood

$15

INSTALLED APPLIANCE, or PIECE OF EQUIPMENT

Regulated by this code, but not classed in other appliance categories, or for which no other fee is listed in this code

$15

SOLID FUEL BURNING APPLIANCE - install, relocate, replace

$25 each

TANK - above-ground, underground, or LPG in a residential application (2)

125-250 gallon capacity

$25 each

over 250 gallon capacity

$50 each

Reference notes:

(1) This fee shall not apply to an air-handling unit, which is a portion of a factory-assembled appliance, cooling unit, evaporative cooler, or absorption unit for which a permit is required elsewhere in this code.

(2) No permit is required for tanks with less than a 125-gallon capacity.

(Added by Amended Ord. 02-064, Dec. 9, 2002, Eff date Feb. 1, 2003; Amended by Amended Ord. 07-084, Sept. 5, 2007, Eff date Sept. 21, 2007; Amended by Amended Ord. 08-122, Nov. 10, 2008, Eff date Jan. 1, 2009; Amended by Amended Ord. 21-048, Sept. 29, 2021, Eff date Nov. 1, 2021).